CAD UNIGRAPHICS

HOW TO USE BEND AND JOG SHEET METAL TOOLS IN UNIGRAPHICS

Follow and Like us:
Facebook
Facebook
Google+
Google+
http://www.mechcadcam.com/how-to-use-bend-and-jog-sheet-metal-tools-in-unigraphics/
YouTube
YouTube

Bend and jog both the tools are used for the modification of model by one side of material.

BEND:

Modifies the model by bending of material on one side of sketch line adding the bend between the two sides.

To create any bends on a particular body we need to draw the sketch first and later on convert that sketch into a particular body.

Now on  a body plot one sketch were we need to bend.After sketching on particular area here we need to convert that area into bending moment.

Select the bend tool which is available in particular tool bar .select the secondary sketch were we want to make bend .

fig shows the formation of bend.

bend

above we can observe the few things

ANGLE:It provides a chance for maintain different angles as per the requirement.

REVERSE DIRECTION & REVERSE SIDE :Here we have a chance of changing directions and sides of the model bend area.

JOG:

Modifies a model by lifting material one side of the sketch line and adding a flange between two sides.

It is completely different from bend.But process of conversion is same as what we did before in bend.

To form any JOGS on a particular body we need to draw the sketch first and later on convert that sketch into a particular body.

Now select the tool JOG and select the sketch where we want to convert.

fig shows the formation of jog.

jog

above we can observe the few things.

HEIGHT:we can adjust the height as per the requirement.

HEIGHT REFERENCE: Here we have two options inside and out side.By using this we can adjust the particular body in required position.

Below videos shows usage of operations

Post Comment